Header Ads Widget
HOME
FLUID MECHANICS
MECHANICS
THERMODYNAMICS
IC ENGINE
STRENGTH OF MATERIAL
PHYSICS
Home
strength of materials
The wide-flange beam has a length of 2L, a depth 2c, and a constant EI. Determine the maximum height h at which a weight W can be dropped on its end without exceeding a maximum elastic stress sigma ma . in the beam.
The wide-flange beam has a length of 2L, a depth 2c, and a constant EI. Determine the maximum height h at which a weight W can be dropped on its end without exceeding a maximum elastic stress sigma ma . in the beam.
sciencekistudyy
September 25, 2022
Post a Comment
0 Comments
Contact US
Name
Email
*
Message
*
Search Question HERE.....
Ask your Question????????
Name
Email
*
Message
*
Labels
FLUID MECHANICS
IC Engine
material science
MECHANICS
PHYSICS
strength of materials
thermodynamics
Report Abuse
Popular Posts
The steel bar has the original dimensions shown in the figure. If it is subjected to an axial load of 50 kN, determine the change in its length and its new cross-sectional dimensions at section a-a. E = 200 GPa, v=0.29
April 11, 2021
Rigid bar is supported by two short white spruce wooden post and spring If each of the post have unloading length of 1m and cross section area of 600 ` mm^2` and spring stiffness of k=3MN/m and unscratched length of 1.02m. Determine the force on each wooden post after the load is applied.
December 23, 2020
At an intersection car B was traveling south and car A was traveling 30° north of east when they slammed into each other. Upon investigation it was found that after the crash the two cars got stuck and skidded off at an angle of 10° north of east. Each driver claimed that he was going at the speed limit of 50 km/h and that he tried to slow down but couldn’t avoid the crash because the other driver was going a lot faster. Knowing that the masses of cars A and B were 1500 kg and 1200 kg, respectively, determine (a) which car was going faster, (b) the speed of the faster of the two cars if the slower car was traveling at the speed limit
October 02, 2022
0 Comments